LINE-X consists of several different products. Utilizing a two-component, spray-in-place, 100% solids (no air pollution), thermoplastic polyurethane and polyurea. The two separate materials are precisely dispensed through a high pressure, plural component internal mixing polyurethane spray machine, which are then heated to 120-140 degrees. Using high pressure, the materials are mixed internally at a 1:1 ratio at the tip of the spray gun. As the material is applied it takes less than 5 seconds for it to LINE-X coating to harden. As soon as LINE-X lands on the surface it’s dry!

Fast Cure, No Runs or Drips

LINE-X products are a fast-cure, multipurpose series of coatings designed for a wide range of retail, commercial, and industrial applications. While exhibiting excellent adhesion, LINE-X can be applied to almost any properly prepared surface. With its fast cure time, LINE-X can be sprayed vertically, horizontally and even overhead without any running or dripping. There are no solvents associated with LINE-X products, which means there are no air pollutants or harmful environmental contaminants.

Hard as Heck and Water Tight

LINE-X Protective Coatings are resistant to most solvents and acids, making LINE-X ideal for industrial and commercial applications where corrosion is prevalent. Using LINE-X greatly extends equipment and vehicle life expectancy. It has a high “shore D” hardness rating, offering excellent impact resistance and superior tensile strengths (up to 6,600 psi) resulting in outstanding abrasion resistance. Because the material is sprayed there is a complete seal, making the coating “watertight”.


Unlike other spray-on or drop-in bed liners, a LINE-X® treatment is professionally applied at high pressure with high temperature, bonding instantly and permanently to your truck.

Made from a two-part polyurethane elastomer system, LINE-X uses equal parts of an “A” component, hardener, and a “B” component, resin. Using special equipment, the two liquids are combined right outside the tip of the spray gun. When the two parts are combined properly, the result is a polyurethane elastomer with tough, durable, protective properties.

The LINE-X dries in just 3 to 5 seconds, preventing running or pooling in comparison to competitors that use a cold, low-pressure spray-on product. With a pre-scheduled appointment, the total job (including bed preparation, masking, and spraying) takes about two hours and your truck is ready immediately.